Do NOT turn off the power during the upgrade process, as it may cause permanent damage to the product. Maximized Range–Powerful external antennas provide far-reaching wireless coverage in every direction. Taken in the kitchen. This is furthest point from router location within home at complete diagonal. Signal will have to pass through a ceiling and 2 walls.

Note: The max share folders number is 10. If you want to share a new folder when the number has reached 10, you can delete an existing share folder and then add a new one. How to setup and provide access to your local storage drive on modem router (self-developed UI) 06-28-2022 65197

I would greatly appreciate some step-by-step guidance on how to set up the TD-W9970 in modem-only mode, to use with an Archer C7 router, over a talktalk fibre IPS.

It is possible to telnet into the modem via LAN1 only. The CLI is a custom TP-Link build and there is no access to the Broadcom CLI and access to the Busybox shell has been disabled. The Local storage sharing feature allows you to share a USB storage device that’s connected to the modem, (USB Drive or mobile Hard Disk Drive) to other wired or wireless users on the same network.Would I expect the Internet light on the W9970 modem-router to turn off once it is put in bridge mode? There are five users here, which provide means to control the access to the USB mass storage by Storage Sharing. The Super User has the right to read and write to Storage Sharing.

It was a pleasant surprise to find this modem performed slightly better on the downstream compared to the HG612 and managed to eke out another 1.5Mbps on the headroom. DSL performance is very stable with low error rate (Err/Secs) compared to some other modems.Two external 4dBi high-gain antennas beam signal to every corner of your home, creating a strong, stable Wi-Fi network. Please verify the hardware version of your device for the firmware version. Wrong firmware upgrade may damage your device and void the warranty. ( Normally Vx.0=Vx.6/Vx.8 (eg:V1.0=V1.6/V1.8); Vx.x0=Vx.x6/Vx.x8 (eg:V1.20=V1.26/V1.28)