Most purchases from business sellers are protected by the Consumer Contract Regulations 2013 which give you the right to cancel the purchase within 14 days after the day you receive the item. They are installed with the cable being protected and are designed to melt and break the circuit in an over-current condition. The standard blade fuse (also known as APR, ATC or ATO fuses) is the most common with many cars now using the mini blade version (also known as APM or ATM fuses).

It has good electrical conductivity, temperature, and pressure resistance, and can be waterproof and dustproof. e. lowest rated component) so that it always blows before any damage occurs to other parts of the electrical circuit. SAFE AND PRACTICAL: Built-in high-current terminals, high-sensitivity, high- waterproof housing and protective rubber bolt caps can protect your trolling motor from electrical damage and save the cost of replacing fuses.

Circuit breakers that have to be manually reset provide an opportunity to check for any problems before using the circuit again and on some types you can manually trip the breaker, which is useful for isolating the circuit and for testing the breaker. The other reason for not fusing the starter circuit is that if the battery is disconnected from the alternator whilst it is turning (as would be the case if a fuse blew) the diodes in the alternator's rectifier can be damaged.

In an ideal world each individual section of positive cable would be fused as this would provide the most protection and make fault finding relatively straight forward, because it would allow you to narrow down the problem to a single section of cable (i. For example, if the normal expected current draw is 10A and the cable size is 25A, then a fuse rated at 15A would be appropriate.It's This battery that's 48v 50AH, but the specs say it goes past 48v, I've seen it go up to 55v if the lcd read out on my current inverter is to be believed. Question is: The BattleBorn manual says to use an ANL fuse, yet I have ready many places that a circuit breaker would be better and the breaker could do double duty as a shut off switch to disable all battery power if needed (only after first turning off solar and AC chargers first). Note that the main feed from the battery is fused to protect this section of cable and this cable should be large enough to supply the current required by all the loads operating at the same time (worst case).

Manual Reset: Visible reset lever shows open condition, unique push button reset can also be used as a kill switch. Compatibility: Newly designed manual reset circuit breaker, compatible with all 12, 24, 48 volt systems. Introduction:- Easy to use and durable, Use in place of an inline fuse holder- Prevent excessive current, protect the electrical appliance- Brand new ,made with high quality parts, apply in connecting audio power line- No More Spending Money on Replacing Fuses- Unique Push Button Reset can also be used as a Kill SwitchSpecifications:Ampere range: 150A. They are also useful where you might need to reset the circuit quickly and don't want to spend time looking for a fuse. The resettable fuse can prevent surges from damaging your amplifier and protect your trolling motor from electrical damage.Fuse are marked with the current that they will continuously pass (at a specified temperature) without blowing, known as the continuous rating. Consequently the fuse used for this cable (fuse 1) will be of a higher rating than fuses 2-5 (see below for selecting a fuse rating). Protection: Prevents excessive current and overload protection for Amps, Audio electronics, audio/video systems and accessories in car, boat, marine vehicles and bikesstops power surges from damaging your amps. Accepts direct connection of 0/2/4/8 gauge power cord to adapter, wired IN (BAT) input, OUT (AUX) output.

Applications: Overload or short circuit protection for automotive audio/video systems, marine, truck, bus, RV, ATV winches, and marine and DC PA systems. Now superseded in modern vehicles by blade fuses but found in some older cars and still used for some classic restorations.This is important because if a section of cable shorts to ground it will only be protected if there is a fuse before the shorting point (otherwise the fuse will not experience the excess current because it will be outside of the short-circuit). Read more about the condition New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable). Generally now used in lower current applications such as audio head units and accessories (cigar lighter socket plugs etc. Unwanted Goods: In accordance with The Consumer Contracts Regulations (2015), you have a 14 working day 'cooling off period' in which you have the right to cancel your purchase and receive a full refund. g. connecting one or more pieces of equipment that draw more current than the circuit is designed to carry or, conversely, using cable of insufficient size for the current draw of the intended equipment.